Topology Dynamic State is not working as intended. Need to add check to set correct Topology class. Circle back to this later. For now revert it.
Some minor fixes.
* Key textures using set and binding (rather than just binding)
* Extend full bindless to cover cases with phi nodes
* Log error on bindless access failure
* Shader cache version bump
* Remove constant buffer match to reduce the chances of full bindless triggering
* Re-enable it for constant buffers, paper mario does actually need it
* Format whitespace
* Report base and extra sets from the backend
* Pass texture set index everywhere
* Key textures using set and binding (rather than just binding)
* Start using extra sets for array textures
* Shader cache version bump
* Separate new commands, some PR feedback
* Introduce new manual descriptor set reservation method that prevents it from being used by something else while owned by an array
* Move bind extra sets logic to new method
* Should only use separate array is MaximumExtraSets is not zero
* Format whitespace
* intel workaround
built on top of the amd workaround
* forgot to update the note
* Logic Change
Enabled workaround for all vendors that aren't nvidia
* Applied Suggestions
* Kernel: Wake cores from idle directly rather than through a host thread
Right now when a core enters an idle state, leaving that idle state requires us to first signal the core's idle thread, which then signals the correct thread that we want to run on the core. This means that in a lot of cases, we're paying double for a thread to be woken from an idle state.
This PR moves this process to happen on the thread that is waking others out of idle, instead of an idle thread that needs to be woken first.
For compatibility the process has been kept as similar as possible - the process for IdleThreadLoop has been migrated to TryLeaveIdle, and is gated by a condition variable that lets it run only once at a time for each core. A core is only considered for wake from idle if idle is both active and has been signalled - the signal is consumed and the active state is cleared when the core leaves idle.
Dummy threads (just the idle thread at the moment) have been changed to have no host thread, as the work is now done by threads entering idle and signalling out of it.
This could put a bit of extra work on threads that would have triggered `_idleInterruptEvent` before, but I'd expect less work than signalling all those reset events and the OS overhead that follows. Worst case is that other threads performing these signals at the same time will have to wait for each other, but it's still going to be a very short amount of time.
Improvements are best seen in games with heavy (or very misguided) multithreading, such as Pokemon: Legends Arceus. Improvements are expected in Scarlet/Violet and TOTK, but are harder to measure.
Testing on Linux/MacOS still to be done, definitely need to test more games as this affects all of them (obviously) and any issues might be rare to encounter.
* Remove _idleThread entirely
* Use spinwait so we don't completely blast the CPU with cmpxchg
* Didn't I already do this
* Cleanup
* Implementing new features in the latest Concentus library - span-in, span-out Opus decoding (so we don't have to make temporary buffer copies), returning a more precise error code from the decoder, and automatically linking the native opus library with P/invoke if supported on the current system
* Remove stub log messages and commit package upgrade to 2.1.0
* use more correct disposal pattern
* Bump to Concentus 2.1.1
* Bump to Concentus 2.1.2
* Don't bother pulling in native opus binaries from Concentus package (using ExcludeAssets).
* Fix opus MS channel count. Explicitly disable native lib probe in OpusCodecFactory.
* Bump to package 2.2.0 which has split out the native libs, as suggested.
---------
Co-authored-by: Logan Stromberg <lostromb@microsoft.com>
* GPU: Migrate buffers on GPU project, pre-emptively flush device local mappings
Essentially retreading #4540, but it's on the GPU project now instead of the backend. This allows us to have a lot more control + knowledge of where the buffer backing has been changed and allows us to pre-emptively flush pages to host memory for quicker readback. It will allow us to do other stuff in the future, but we'll get there when we get there.
Performance greatly improved in Hyrule Warriors: Age of Calamity. Performance notably improved in TOTK (average). Performance for BOTW restored to how it was before #4911, perhaps a bit better.
- Rewrites a bunch of buffer migration stuff. Might want to tighten up how dispose stuff works.
- Fixed an issue where the copy for texture pre-flush would happen _after_ the syncpoint.
TODO: remove a page from pre-flush if it isn't flushed after a certain number of copies.
* Add copy deactivation
* Fix dependent virtual buffers
* Remove logging
* Fix format issues (maybe)
* Vulkan: Remove backing swap
* Add explicit memory access types for most buffers
* Fix typo
* Add device local force expiry, change buffer inheritance behaviour
* General cleanup, OGL fix
* BufferPreFlush comments
* BufferBackingState comments
* Add an extra precaution to BufferMigration
This is very unlikely, but it's important to cover loose ends like this.
* Address some feedback
* Docs
* Block input updates while swkbd is open in foreground mode
* Flush internal driver state before unblocking input updates
* Rename Flush to Clear and remove unnecessary attribute
* Clear the driver state only if the GamepadDriver isn't null
* Update audio renderer to REV12: Add support for splitter biquad filter
* Formatting
* Official names
* Update BiquadFilterState size + other fixes
* Update tests
* Update comment for version 2
* Size test for SplitterDestinationVersion2
* Should use Volume1 if no ramp
* Block input updates while swkbd is open in foreground mode
* Flush internal driver state before unblocking input updates
* Rename Flush to Clear and remove unnecessary attribute
* Add "Follow OS theme" option
* Update App.axaml.cs
* Add "Follow OS theme" option
* Update App.axaml.cs
* Remove `this`
* Remove annotation for nullable reference
* Change into switch expression to make it concise
* Change comments to XML docs
* Update en_US.json
* Fix icons in About dialog do not response to "auto" theme
The theme icons seemingly use Dark variant event when the OS theme is light. In addition, I added ThemeManager common to make it accessible for both App and AboutWindow
* Newline at the end
* newline moment
* Update ThemeManager.cs
* bait to switch to lf
* change to lf
* temp. revert
* Add back ThemeManager.cs common, pls pass the format check
* I found the mistake: should have put `ThemeManager.OnThemeChanged();` in try block
Finally solve the formatting check
* test formatting
* Update App.axaml.cs
* Ok i seem to forget to add version lol
* Fix info CA1816
* Truncate game title and details if they exceed DiscordRPC limit.
* Update implementation to a byte total check.
* Track if the string has actually been modified correctly.
* Allow an early function return and simplify logic.
* Better handling of large input strings and minimise loop opportunities.
* Remove unused using.
* Update to `applicationName` over `titleName`.
* Add files via upload
* Update IHidServer.cs
mistakes...
* format
how do i do it
* Update src/Ryujinx.HLE/HOS/Services/Hid/IHidServer.cs
Co-authored-by: Agatem <agaatem@outlook.com>
* Update src/Ryujinx.HLE/HOS/Services/Hid/IHidServer.cs
Co-authored-by: Agatem <agaatem@outlook.com>
* bruh
* Apply suggestions from code review
Co-authored-by: gdkchan <gab.dark.100@gmail.com>
* use readuint32 instead
* second thought
* i hope it works
thanks someone higher up with the same thing
* pid
* Apply suggestions from code review
Co-authored-by: Ac_K <Acoustik666@gmail.com>
* styles i think
* Apply suggestions from code review
Co-authored-by: makigumo <makigumo@users.noreply.github.com>
---------
Co-authored-by: Agatem <agaatem@outlook.com>
Co-authored-by: gdkchan <gab.dark.100@gmail.com>
Co-authored-by: Ac_K <Acoustik666@gmail.com>
Co-authored-by: makigumo <makigumo@users.noreply.github.com>
